Always be sure that the tool i s switched off and unplugged before attempting to perform
inspection or maintenance.
Cleaning the clamp on the blade holder
If chips or foreign matter
into the clamp on the blade holder, clean out the clamp
from the blade holder. To remove the clamp, rotate the blade installing
lever (for 4304T) or knob (for 4305T) in the blade loosening direction
Then remove the clamp from the blade holder while rotating the clamp counterclock-
wise. To install the clamp, first make sure that the blade installing lever (for 4304T) or
knob (for 4305T) has been rotated in the blade loosening direction as far as possible.
Insert the clamp into the blade holder while rotating it clockwise one quarter to one full
turn. Grasp the clamp with your fingers
that it will not turn, then rotate the blade
installing lever or knob in the blade tightening direction
that the clamp will go into the
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or
adjustment should be performed
Makita Authorized or Factory Service Centers,
always using Makita replacement parts.