Troubleshooting Chart - Sharp CD-G10000V Operation Manual

! Headphones
" Before plugging in or unplugging the headphones, reduce the
volume.
" Be sure your headphones have a 3.5 mm (1/8") diameter plug
and impedance between 16 and 50 ohms. The recommended
impedance is 32 ohms.
" Plugging in the headphones disconnects the speakers automati-
cally. Adjust the volume using the VOLUME control.

Troubleshooting chart

Many potential problems can be resolved by the owner without call-
ing a service technician.
If something is wrong with this product, check the following before
calling your authorised SHARP dealer or service centre.
! General
Symptom
" The clock is not set to the " Did a power failure occur? Reset
correct time. the clock. (Refer to page 18.)
" When a button is pressed, " Set the unit to the power stand-
the unit does not respond. by mode and then turn it back on.
" If the unit still malfunctions, reset
it. (Refer to page 48.)
" No sound is heard. " Is the volume level set to "0"?
" Are the headphones connected?
" Are the speaker wires discon-
nected?
" Is the karaoke mode set to "L-
CH", "R-CH" or "V-CANCEL"?
! Video CD
Symptom
" The picture is not dis- " Is the TV unplugged?
played during playback.
" Is the unit connected improperly?
" Is the input selector on the TV set
to other than "VCR"?
" Is the unit being played without
selecting video CD?
" The picture quality is poor, " Is the disc very dirty?
or it is distorted.
04/3/22 CD-G10000V(Z)E5.fm
CD-G10000V
CP-G10000
ENGLISH
Possible cause
Possible cause
E-46
TINSZA092AWZZ
4