Sharp XL-MP9H Operation Manual page 37

7
When the preset time is reached, playback will start.
The volume will increase gradually until it reaches the volume
you were listening at before your system enters the timer stand-
by mode.
8
The unit will enter the stand-by mode one hour after the
timer playback starts. However, when disc playback time is
one hour or less, it will enter the stand-by mode after com-
pleting playback.
To reset or change the timer setting:
Perform "Timer playback" from the beginning.
Note:
When performing timer playback using another unit connected to
the LINE sockets, select "AUX" in step 2. At this time, only this unit
will be turned on or enter the power stand-by mode automatically. It
will enter the power stand-by mode 1 hour after the timer playback
starts. However, the other unit will not be turned on or off.
! To use timer and sleep operation together
Example: To fall asleep and wake up to the same radio station
You can play back the same source only (the function cannot be
switched).
1
Set the sleep time (steps 1 - 2 on the right).
2
Whilst the sleep timer is set, set the desired playback time
(steps 4 - 6, page 25).
Sleep timer setting Timer playback setting
5 minutes - 3 hours
Sleep operation will
automatically stop.
! Sleep operation
1
Play back the desired sound source.
2
Press the SLEEP button.
On the remote control, press the SHIFT
button and then the SLEEP button.
To change the sleep time:
Time decreases as follows each time they are pressed.
The amount of sleep time can also be changed whilst in the
sleep mode.
(Maximum: 3 hours - Minimum: 5 minutes)
3
Your system will enter the power stand-by mode automat-
ically after the preset time has elapsed.
The volume will turn down 30 seconds before the sleep opera-
tion finishes.
To cancel the sleep operation:
Press the ON/STAND-BY button whilst "SLEEP" is indicated.
To cancel the sleep operation without setting the system to the
stand-by mode, press the SLEEP button until "OFF" appears on the
display.
" On the remote control, press the SHIFT button and then the
SLEEP button.
To confirm the remaining sleep time:
Press the SLEEP button once whilst the sleep timer is set.
" On the remote control, press the SHIFT button and then the
SLEEP button.
The remaining sleep time is displayed for about 8 seconds.
Timer playback
start time
05/5/23
3:00 2:00 1:30 1:00
OFF 5 10 15 30
XL-MP9H(H)E3.fm
XL-MP9H
ENGLISH
8
E-26
TINSZA058SJZZ