Page 1
Thank you for purchasing this SHARP product. XL-MP130 To obtain the best performance from this product, please read this manual carefully. It will guide you in operating your SHARP product. XL-MP110E Micro Component System consisting of XL-MP110E (main MICRO COMPONENT SYSTEM unit) and CP-MP110E (speaker system).
System connections XL-MP110E Make sure to unplug the AC power lead before any connections. Aerial connection (see page 9) FM aerial AM loop aerial Right speaker Left speaker ANTENNA LOOP 75 OHMS VIDEO/AUX RIGHT LEFT RATED SPEAKER IMPEDANCE: 6 OHMS MIN. AC INPUT SUBWOOFER RIGHT...
Page 9
XL-MP110E Aerial connection Speaker connection Supplied FM aerial: Connect the black wire to the minus (-) terminal, and the red wire to Connect the FM aerial wire to the FM 75 OHMS terminal and position the plus (+) terminal. the FM aerial wire in the direction where the strongest signal can be received.
System connections (continued) XL-MP110E AC power connection Demonstration mode After checking all the connections have been made correctly, plug The first time the unit is plugged in, the the AC power lead of this unit into the wall socket. If you plug in the unit will enter the demonstration mode.
Remote control XL-MP110E Battery installation Notes concerning use: Replace the batteries if the operating distance is reduced or if the Use 2 "AA" size batteries (UM/SUM-3, R6, HP-7 or similar). operation becomes erratic. Periodically clean the transmitter on the remote control and the Batteries are not included.
General control XL-MP110E Volume control Main unit operation: When the VOL +/- control is turned clockwise, the volume will increase. When it is turned anti-clockwise, the volume will decrease. Remote control operation: Press the VOLUME (+ or -) button to increase or decrease the volume. 0 ..
Setting the clock XL-MP110E Press the button to adjust the hour and then press the MEMORY/SET button. Press the button once to advance the time by 1 hour. Hold it down to advance continuously. Press the button to adjust the minutes and then press the MEMORY/SET button.
Listening to a CD or MP3/WMA disc XL-MP110E This system can play back a standard CD, CD-R/RW in the CD format and CD-R/RW with MP3 or WMA files, but cannot record on them. Some audio CD-R and CD-RW discs may not be playable due to the state of the disc or the device that was used for recording.
Page 15
XL-MP110E Playback will begin from track 1 on DISC 1. After that disc fin- Press the ON/STAND-BY button to turn the power on. ishes playing, the next disc will automatically play. After the last track on the fifth disc is played, the unit will stop Press the CD button.
Page 16
Listening to a CD or MP3/WMA disc (continued) XL-MP110E Various disc functions Notes for CD: Track up/track down is possible only within individual discs. Function Main unit Remote Operation Fast forward/fast reverse is possible only within individual discs. control When the end of the last track is reached during fast forward, Play Press in the stop "END"...
Page 17
XL-MP110E To change the display (MP3/WMA discs only) To select the desired folder or track by name Whilst in the stop mode or playback mode, press the DISPLAY (MP3/WMA discs only) button. Each time the button is pressed, the display will change as follows. Whilst in the stop mode, press the DISPLAY button to display the folder name.
Advanced CD or MP3/WMA disc playback XL-MP110E To specify a disc to play Direct track search You can play a disc by specifying the disc number. By using the direct search buttons, the desired tracks on the current disc can be played. Press one of the 5 buttons to select the desired disc.
Page 19
XL-MP110E Repeat play Random play Repeat play can play all 5 discs, all tracks on a chosen disc, or a The tracks on the disc(s) can be played in random order automatically. programmed sequence continuously. To random play all tracks on up to 5 discs: To repeat all tracks on up to 5 discs: Press the RANDOM button on the remote control.
Page 20
Advanced CD or MP3/WMA disc playback (continued) XL-MP110E Programmed play To clear the programmed selections: Press the CLEAR/DIMMER button on the re- You can choose up to 32 selections for playback in the order you like. mote control whilst the "MEMORY" indicator Whilst in the stop mode, press is flashing.
Listening to the radio XL-MP110E Tuning Press the ON/STAND-BY button to turn the power on. Press the TUNER (BAND) button repeatedly to select the desired frequency band (FM or AM). Press the TUNING ( ) button to tune in to the desired station.
Listening to the radio (continued) XL-MP110E Memorising a station To recall a memorised station You can store 40 AM and FM stations in memory and recall them at Press the PRESET ( ) button for less than 0.5 seconds to se- the push of a button.
Listening to a cassette tape XL-MP110E Tape playback Before playback: For playback, use normal or low-noise tapes for Press the ON/STAND-BY button to turn the power on. the best sound. (Metal or CrO tapes are not rec- Press the TAPE button. ommended.) Do not use C-120 tapes or poor-quality tapes, as Open the cassette door by push-...
Main unit Remote Operation ensure that the desired material is properly recorded. control SHARP is not liable for damage or loss of your recording arising Playback Press in the stop from malfunction of this unit. mode. The volume and sound controls can be adjusted with no effect on the recorded signal (Variable Sound Monitor).
Page 25
XL-MP110E Recording from a CD or MP3/WMA disc You can record the desired disc using the CD DIRECT PLAY button. Press the ON/STAND-BY button to turn the power on. Press the CD button. Load a cassette into the cassette compartment with the side to be recorded on facing you.
Page 26
Recording on a cassette tape (continued) XL-MP110E Recording from several CDs continuously: Recording from the radio 1 Perform steps 1 - 5 in "Recording from a CD or MP3/WMA disc" Tune in to the desired station (see page 21). on page 25. 2 Within 5 seconds, press the (TAPE ) button to start record- Load a cassette into the cassette compartment with the...
Timer and sleep operation XL-MP110E Timer playback: The unit turns on and plays the desired source (CD, tuner, tape) at a preset time. Timer recording: The unit turns on and starts recording from the tuner at the preset time. This unit has 2 types of timer: ONCE TIMER and DAILY TIMER. Once timer: Once timer play or once timer recording works for one time only at a preset time.
Page 28
Timer and sleep operation (continued) XL-MP110E Within 10 seconds, press the button to se- Switch input with the button, and then lect "ONCE SET" or "DAILY SET", and press the MEMORY/ press the MEMORY/SET button. SET button. To select the timer playback source: CD, TUNER or TAPE. To select the timer recording source: TUNER.
Page 29
XL-MP110E Checking the timer setting in the timer stand-by mode: When the preset time is reached, playback or recording will 1 Press the CLOCK/TIMER button. start. 2 Within 10 seconds, press the button to select "ONCE" or "DAILY", and press the MEMORY/SET button. The volume will increase gradually until it reaches the preset 3 Within 10 seconds, press the button to select...
Timer and sleep operation (continued) XL-MP110E Sleep operation To cancel the sleep operation: Press the ON/STAND-BY button whilst "SLEEP" is indicated. The radio, compact disc and cassette tape can all be turned off au- To cancel the sleep operation without setting the unit to the stand-by tomatically.
Enhancing your system XL-MP110E The connection lead is not included. Purchase a commercially avail- Listening to the playback sounds from VCR, able lead as shown below. DVD, etc. VCR, DVD, etc. Use a connection lead to connect the VCR, DVD, etc. to the VIDEO/AUX IN sockets.
If something is wrong with this product, check the following before connected to this unit, you can enjoy sound with emphasised bass. calling your authorised SHARP dealer or service centre. Connect an RCA lead from a commercially available speaker with a built-in amplifier to the SUBWOOFER PRE-OUT socket.
Page 33
XL-MP110E Cassette deck Tuner Symptom Possible cause Symptom Possible cause Cannot record. Is the erase-prevention tab re- The radio makes unusual Is the unit placed near the TV or moved? noises continuously. computer? Cannot record tracks with Is it a normal tape? (You cannot Is the FM aerial or AM loop aerial proper sound quality.
Page 34
Troubleshooting chart (continued) XL-MP110E If trouble occurs Before transporting the unit When this product is subjected to strong external interference (me- Remove all CDs from the unit. Make sure there is no CD in the disc chanical shock, excessive static electricity, abnormal supply voltage tray.
Maintenance XL-MP110E Cleaning the tape-handling parts Cleaning the cabinet Dirty heads, capstans or pinch rollers can cause poor sound and Periodically wipe the cabinet with a soft cloth and a diluted soap solution, then with a dry cloth. tape jams. Clean these parts with a cotton swab moistened with commercial head/pinch roller cleaner or isopropyl alcohol.
Specifications XL-MP110E As part of our policy of continuous improvement, SHARP reserves Frequency 20 - 20,000 Hz the right to make design and specification changes for product response improvement without prior notice. The performance specification fig- Dynamic range 90 dB (1 kHz) ures indicated are nominal values of production units.
Consumer Electronic Products Congratulations on Your Purchase! This Sharp product is warranted against faults in materials and manufacture for a period of twelve(12) months from the date of original purchase. If service is required during the warranty period, please contact your nearest Sharp Approved Service Centre.