Antenna Connection - Sharp SD-SH111 Operation Manual

Speaker connection
Connect the speaker wire (not supplied) to SPEAKERS terminals.
Speaker wire
Caution:
Connect the speaker wires to the speakers first, then to the unit.
Use a speaker system which has 50 W or more rated power input and 4
ohms impedance.
If the volume is turned up too high with the speakers of less than 4 ohms
impedance connected, the protection circuit of the amplifier activates. Noth-
ing is heard temporarily.
Do not mistake the right and the left channels. The right speaker is the one on the
right side when you face the unit.
Do not short- circuit the speaker lead. If it happens with the power on, the
protection circuit is activated and the unit is set to the power stand-by mode.
In this case, check that the speaker lead is connected correctly before turn-
ing on the power again.

Antenna connection

Supplied FM antenna:
Connect the FM antenna wire to the FM 75
OHMS jack and position the FM antenna wire in
the direction where the strongest signal can be
received.
Supplied AM loop antenna:
Connect the AM loop antenna wire to the AM
and GND terminals. Position the AM loop anten-
na for optimum reception. Place the AM loop an-
tenna on a shelf, etc., or attach it to a stand or a
wall with screws (not supplied).
Notes:
Placing the antenna on the unit or near the AC power cord may cause noise
pickup. Place the antenna away from the unit for better reception.
When static is still heard even after adjusting the position of the AM loop antenna,
try reversing the wire connections.
Installing the AM loop antenna:
< Assembling >
Outdoor FM or AM antenna:
Use an outdoor FM or AM antenna if you require better reception. Consult your
dealer.
Outdoor
Outdoor AM antenna
FM antenna
49 feet (15 m)
25 feet (7.5 m )
Ground rod
Note:
When using an outdoor AM antenna, be sure to keep the wire of the AM loop antenna
connected.
02/11/20 SD-SH111(U)E2.fm
SD-SH111
ENGLISH
White
Black
< Attaching to the wall >
Wall Screws (not supplied)
AM loop antenna
E-14
7