Table of Contents
Advertisement
73218pr-0920.qrk 5/21/01 2:29 PM Page 24
H
IMPORTANT! Use only Power Wheels
with A-style connectors and built-in thermal fuses. Power
Wheels
®
6 volt batteries with external thermal fuses
will not fit in the battery compartment of this vehicle.
Use of any other batteries or fuses will damage your
vehicle. Make sure that you charge the batteries for at
least 18 hours using the enclosed Power Wheels
charger before operating your vehicle for the first time.
Charge the batteries for at least 14 hours after each use of
the vehicle. Never charge the batteries longer than 30
hours. Failure to follow these instructions may damage
your batteries and will void your warranty.
1
Battery
Compartment
Vehicle
Body
• Place the Power Wheels
battery compartment. Make sure that the battery
connectors extend toward the left side of
the vehicle.
Battery Installation
®
6 volt batteries
12 volt
®
Power Wheels
6 Volt Batteries
®
6 volt batteries upright in the
2
Screw
Peg
®
• Fit the battery clamp over the batteries diagonally.
• Insert a screw through each end of the battery clamp
and into the screw pegs on the vehicle body.
• Tighten the screws using a Phillips screwdriver.
Do not over-tighten.
3
Motor
Harness
Connector
GAP
Incorrect
• Plug the battery and motor harness connectors together.
24
Push firmly to snap the two connectors together.
Battery
Clamp
Screw
Peg
Battery
Connector
Batteries
NO GAP
Correct
Advertisement
Table of Contents
