Battery Installation - Fisher-Price POWER WHEELS LittlePeople N8415 Owner's Manual With Assembly Instructions

IMPORTANT! Use only a Power Wheels
battery and built-in thermal fuse. Use of any other battery will
damage your vehicle. Make sure that you charge the battery
for at least 18 hours using the enclosed Power Wheels
(4.0 Amp/Hr.) charger before operating your vehicle for the first
time. Charge the battery for at least 14 hours after each use
of the vehicle. Never charge the battery longer than 30 hours.
Failure to follow these instructions may damage your battery
and will void your warranty.
N8415pr-0920

BATTERY INSTALLATION

®
6 volt (4.0 Amp/Hr.)
® 6 volt
Battery Door
1
• Using a Phillips screwdriver, loosen the screw in the battery door.
• Remove the battery door.
• Remove the #8 x 1" (2.5 cm) screw from the battery retainer.
Lift to remove the battery retainer from the vehicle.
• Place the Power Wheels ® 6 Volt (4.0 Amp/Hr.) battery in the
battery compartment. Make sure the battery connector extends
toward the rear of the vehicle.
• Replace the battery retainer over the battery. Insert the #8 x 1"
(2.5 cm) screw through the battery retainer and into the vehicle.
Tighten the screw.
• Plug the battery connector into the motor harness connector.
Note: If the battery connector will not plug into the motor harness
connector, turn it over and try again! Do not force the battery
connector into the motor harness connector.
• Fit the tabs on the battery door into the vehicle. Using a Phillips
screwdiver, tighten the screw.
IMPORTANT! Always remember to keep the screw tightened at
all times to prevent children from accessing the battery.
11