Table of Contents
Advertisement
73218pr-0920.qrk 5/21/01 2:29 PM Page 17
24
• Slide the fork axle up into the bottom of the front fork,
through the neck and steering stop, and out the top of
the front fork.
• Fit a .354 (small diameter) cap nut on the end of the
fork axle.
• Support the fork axle and tap the cap nut with a hammer
to secure it on the end of the axle.
• Pull on the .354 cap nut to make sure it is secure on the
fork axle.
25
Handgrip
• Fit a handgrip on the end of each handlebar.
• Note the R (right) and L (left) markings on the handlebars.
Note: If it is difficult to slide the handgrips onto the
handlebars, moisten the inside of the handgrips
with water.
.354 (Small
Diameter)
Cap Nut
Front
Fork
Fork Axle
Handlebars
Handgrip
"R"
"L"
Assembly
26
• Slide the right and left handlebars through the holes in
the front fork.
• Align the screw holes in each handlebar with the screw
holes in the front fork.
• Insert a #8 x
3
/
" screw through each front fork and into
4
each lower hole in each handlebar
screws with a Phillips screwdriver. Do not over-tighten.
• Insert a #8 x
3
/
" screw through each front fork and into
4
each upper hole in each handlebar
screws with a Phillips screwdriver. Do not over-tighten.
17
Right
Handlebar
Left
Handlebar
Front
Fork
2
1
1
. Tighten the
2
. Tighten the
Advertisement
Table of Contents
