Table of Contents
Advertisement
73218pr-0920.qrk 5/21/01 2:29 PM Page 21
37
Mirror Housing
• Fit a mirror lens to a mirror housing.
1
• Insert a #8 x
/
" screw through the back of the mirror
2
housing into the mirror lens. Tighten the screw with a
Phillips screwdriver. Do not over-tighten.
• Repeat this procedure to assemble the other mirror lens
to the remaining mirror housing.
38
Mirror Housing
Handlebar
• Fit a mirror housing to a handlebar, as shown.
• Fit and hold a mirror clamp to the other side of
the handlebar.
• Insert two #8 x
3
/
" screws through the back of the mirror
4
housing and into the mirror clamp.
• Using a Phillips screwdriver, tighten the screws to hold
the mirror housing upright. Do not over-tighten.
• Repeat this procedure to assemble the remaining mirror
housing to the other handlebar.
Assembly
Mirror Lens
• Fit the fender tip onto the front of the fender.
• Insert two #8 x
Mirror Clamp
21
39
Vehicle
Frame
3
/
" screws through the fender tip and
4
into the vehicle frame. Tighten the screws with a Phillips
screwdriver. Do not over-tighten.
Front
Fender
Fender Tip
Advertisement
Table of Contents
