Installing The Control Unit; Important Installation Information For The Speedometer Signal; Connecting The Speedometer Signal; Connecting The Back-Up Lights Signal Wire - Blaupunkt TravelPilot DX-N Installation Instructions Manual

Installation

Installing the control unit

Mount the control unit bracket in a location where the control
unit will be easily accessible, e.g. on the centre console.
Important!
Do not mount the control unit within the inflation range of the
airbags (on the driver's side, the passenger side or the side air-
bags) or where it might strike the head or knees of anyone in the
vehicle in the event of an accident!
Before drilling the holes for the mounting screws, make sure that
no damage will be done to covered wiring, the petrol tank or fuel
lines!
Make sure that the vehicle operating elements remain easily
accessible and are not obstructed in any way (gear stick, hand
brake, etc.)!
Important installation information for
the speedometer signal
When connecting the speedometer signal, make sure to
observe the following information:
1. Where to find the signal: For many vehicles, the speedom-
eter signal can be found in the vehicle-specific car radio plug.
Contact the customer service of the vehicle manufacturer or
an authorised navigation dealer to find out what the exact pin
allocation is.
2. Do not use the speedometer signal from ABS control units or
control circuits.
Allgemeines Kurzanlei- Zieleingabe Touren
3. Important:
We assume no responsibility for any equipment that is in-
stalled incorrectly and the consequences thereof!

Connecting the speedometer signal

Important: This connection should be made by an authorised
customer service centre.
The connection is made with the speedometer signal wire
(8 618 841 988) to the vehicle-specific speedometer signal con-
nection. (see connection diagram, page 18).
Connecting the back-up lights signal
wire
Important : This connection should be made by an authorised
customer service centre.
The connection is made with the back-up lights signal wire
(8 618 842 033) to the vehicle back-up lights. Make sure that
there are +12V at the connection when the vehicle is backing up
(see connection diagram, page 18).
Important:
We assume no responsibility for any equipment that is installed
incorrectly and the consequences thereof!
Zielspeicher Einstellun-
7
Anhang