Connecting The Speakers; Installing The Antenna - Blaupunkt TravelPilot DX-R52 Installation Instructions Manual

2. Connecting the speakers

2.1 Connecting the speakers to the
ISO standard plug
In vehicles pre-equipped with pas-
sive speakers (with 4-ohm speakers)
you can adapt the ISO plug in the
vehicle. If necessary, the ISO cable
(Order-No.7 607 647 093) can bd¯]sed
for extra length (see Fig. 4). Order spe-
cial adapter cables from your dealer
for vehicles pre-equipped with active
speakers.

3. Installing the antenna

Connect the antenna wiring to the en-
closed bracket (see Fig. 5).
3.1 Radio antenna
In pre-equipped vehicles (e.g.: VW,
Seat, Audi), the antenna gets its pow-
er supply via the antenna wire (see the
vehicle operating instructions). If you
want to replace the OEM radio with a
conventional radio, you will have to
order an antenna supply diplexer (Or-
der-No. 7 691 290 202) or the adapter
cable (Order-No. 7 607 621 129) from
your dealer. You will find information
on the installation and connection of
the antenna in the antenna installation
instructions. (see Fig. 5).
3.2 GPS antenna (satellite navigation)
You will find information on how to in-
stall the antenna in the enclosed an-
tenna installation instructions.
If the GPS antenna is installed inside
the vehicle, we cannot guarantee that
the system will function correctly.
4. Installing the TravelPilot
4.1 Setting the Gyro
Important: Before the TravelPilot is
inserted, the gyroscope must be put in
a horizontal position (see Fig. 8).
Important: Installation position of the
TravelPilot: right / left: min. -5˚/ max.
+5˚, front to back: min. -10˚ / max. +30˚
The TravelPilot is installed in the
standard car radio compartment pro-
vided by the manufacturer (see Fig. 6 ).
For vehicles without a DIN compart-
ment, Blaupunkt offers vehicle-specif-
ic installation kits for 50/52 mm units
for the most popular vehicle models.
Please check the installation condi-
tions in your vehicle and use a vehi-
cle-specific installation kit if necessary.
4.2 Installing the bracket
The bracket included with this Travel-
Pilot allows you to install the system in
vehicles with a DIN car radio compart-
ment measuring 182 x 53 x165 mm
and an instrument panel which is 1 to
20 mm in the area where the fastener
tabs are located, (see Fig. 6). For the
installation, you have to push the
bracket into the compartment and de-
termine which fastener tabs you can
bend over with a screwdriver (see
Fig. 6a).
Note: Bend over as many of the fas-
tener tabs as possible.
4.3 Installing the TravelPilot
Push all of the plugs into the sockets
until they lock into place. Now insert
the navigation system from the front
into the bracket. Apply gentle pressure
to both side edges and push it in until
the spring locks snap into position on
the right and left (you will hear a loud
click).
Important! When you push in the sys-
tem, make sure that you do not put any
pressure on the display, the knobs or
the keys!
257