Installing The Display; Safety Instructions; Display Installation; Display De-Installation - Blaupunkt TravelPilot DX-N Installation Instructions Manual

Hide thumbs Also See for TravelPilot DX-N:
Table of Contents

Advertisement

Installation

Installing the display

Safety instructions

Never grease or oil the ball-and-socket joint.
The monitor cable must be laid so that it is not subjected
to any tensile strains or other loads.
Important!
Do not mount the monitor within the inflation range of
the airbags (on the driver's side, the passenger side or
the side airbags) or where it might strike the head or knees
of anyone in the vehicle in the event of an accident!
Before drilling the holes for the mounting screws and
wiring, make sure that no damage will be done to cov-
ered wiring, the petrol tank or fuel lines!

Display installation

Fig. 3 The display is mounted on the dashboard or console us-
ing the enclosed ball-and-socket
Fig. 4 The display is mounted directly on a console (telephone
console) with the ball joint.
Fig. 5 The display is mounted using the swan neck fitting 7 612
001 204 and the ball-and-socket base. To do so, you must
disassemble the rear panel of the display.
A 10 mm wide hole must be drilled at the mounting posi-
tion to accommodate the cable. When the cable is in-
stalled, you must ensure it will safe from being tugged or
stretched or from being exposed to any other loads.
base.
Display de-installation (Fig. 6)
1. Unscrew the four screws on the back of the display and re-
move the rear panel.
2. Pull out the plugs carefully and push them through the mount-
ing base.
3. Then use the mounting material you require.

Installing the speaker

Install the speaker used for the spoken driving recommenda-
tions in the footwell of the vehicle.
Important!
Make sure that the vehicle operating elements remain easily
accessible and are not obstructed in any way by the connection
cable and the location of the speaker (gear stick, hand brake,
accelerator, clutch or brake pedals, etc.)!
Important!
Before drilling the holes for the mounting screws, make sure that
no damage will be done to covered wiring, the petrol tank or fuel
lines!
6

Advertisement

Table of Contents
loading

Table of Contents