Installing The Display; Safety Instructions; Uninstalling The Display; Installing The Control Unit - Blaupunkt TravelPilot DX-V Installation Instructions Manual

Installation

Installing the display

Safety instructions

The display support must never be greased or lubricated
with oil.
The monitor cable must be laid so that it is not subjected
to any tensile strains or other loads.
Important!
Do not mount the monitor within the inflation range of
the airbags (on the driver's side, the passenger side or
the side airbags) or where it might strike the head or knees
of anyone in the vehicle in the event of an accident!
Before drilling the holes for the mounting screws and
wiring, make sure that no damage will be done to cov-
ered wiring, the petrol tank or fuel lines!
Installing the display
1. Attach the display support to the display (Fig. 2, Page 13).
Mount the display together with its support onto the dash-
board or console (Fig. 3, Page 13).
Connect the cables and run them towards the navigation unit.

Uninstalling the display

1. Press the tab on the plug and carefully pull out the plug (do
not pull on the cable) (Fig. 4, Page 13).
2. Push together the lugs on the display support and pull out
the display in an upwards direction (Fig. 4, Page 13).

Installing the control unit

Mount the control unit bracket in a location where the control
unit will be easily accessible, e.g. on the centre console.
Important!
Do not mount the control unit within the inflation range of the
airbags (on the driver's side, the passenger side or the side air-
bags) or where it might strike the head or knees of anyone in the
vehicle in the event of an accident!
Before drilling the holes for the mounting screws, make sure that
no damage will be done to covered wiring, the petrol tank or fuel
lines!
Make sure that the vehicle operating elements remain easily
accessible and are not obstructed in any way (gear stick, hand
brake, etc.)!
Note:
The "wide screen" monitor is equipped with an integrated
infrared receiver. This means that the supplied receiver for
the RC 09H does not necessarily have to be installed.
Important installation information for
the speedometer signal
When connecting the speedometer signal, make sure to
observe the following information:
1. Where to find the signal: For many vehicles, the speedom-
eter signal can be found in the vehicle-specific car radio plug.
Contact the customer service of the vehicle manufacturer or
an authorised navigation dealer to find out what the exact pin
allocation is.
6