Registering Handsets - Polycom KWS600v3 Installation And Configuration Manual

The figure below shows an example of how to complete the required fields.

Registering Handsets

To configure specific handsets with identities so that they can make calls:
Under the Administration menu, select DECT and then select Users.
1.
Select New. An Edit User dialog box will appear.
2.
In the Long Name field, enter any name.
3.
In the Name field, enter the identity (extension). Refer to
4.
instructions on locating the identity. No spaces are allowed.
In the Number field, enter the SIP identity address (extension). Refer to
5.
on page 6 for instructions on locating the SIP identity address.
In the Password field, enter the SIP authentication password. Refer to
6.
page 6 for instructions on locating the SIP authentication password.
In the Display Text field, enter a standby text. This is displayed on the handset. This can be the
7.
identity or a name to identify the location of the handset.
In the IPEI field, enter the IPEI number (serial number) of the handset. Refer to
8.
Information on page 6
In the Auth Code field, if you previously selected With User AC in
9.
System on the KWS600v3 on page
Select Apply.
10.
Repeat Steps 1 through 10 for each new handset to be registered to the system.
11.
Select OK to save the registration(s).
12.
for instructions on locating the IPEI.
9, enter the numerical access code.
11
Gathering Information on page 6
Gathering Information
Gathering Information on
Gathering
Configuring the DECT
for