Siemens Gigaset AL110 User Manual page 5

Placing the handset in the base/charging cradle
¤
Place the handset in the base/charging cradle with its display facing forward.
Each handset is registered with the base at the factory. You do not need to complete a regis-
tration. If you wish to use your handset with a different base or use further handsets with your
base, you will have to register the handset manually (
To charge the batteries, leave the handset in the base/charging cradle.
Please note
Only place the handset in the base/charging cradle that is intended for it.
Initial charging and discharging of the batteries
The correct charge level can only be displayed if the batteries are first fully charged and dis-
charged.
Please note
◆
After the first battery charge and discharge you may replace your handset in the base/
charging cradle after every call.
◆
Always repeat the charging and discharging procedure if you remove the batteries
from the handset and reinsert them.
◆
The batteries may warm up during charging. This is not dangerous.
◆
After a while, the charge capacity of the batteries will decrease for technical reasons.
Setting the date and time
Set the date and time so that the correct date and time can be assigned to incoming calls, and
so that the alarm can be used.
¢ ¢
¢ ¢
MENU Settings OK
~
¢ ¢
Date: (enter the day, month and year in 6-digit format)
~
¢
Time: (enter hours and minutes in 4-digit format)
a
(press and hold to return to idle status)
Please note
When entering the time and date, you can move the position of an entry to the left or right
by pressing the control button up or down.
5
¤
Place the handset in the base/charging cradle for 7 hours.
7 h
¢ ¢
Date/Time OK
¢
p. 10).
¤
Then remove the handset from the
base/charging cradle and do not
replace it until the batteries are fully
discharged.
¢
¢
OK
OK (display message: Saved)