Table of Contents
Advertisement
Put the cover back in place and screw it on.
7.
Attach the oven door.
8.
Do not use the oven again until the panels have been
correctly installed.
Troubleshooting
Quite often, when there is a malfunction, it is usually a small
irregularity which is easy to rectify. Before contacting the
Technical Assistance Service, try to determine the cause of the
fault using the following table.
Troubleshooting table
Fault
Possible cause
The oven does
The fuse has
not work.
blown.
Power cut
Power cut
The
symbol
0
lights up on the
display with
some zeros.
The oven does
There is dust in the
not work.
contacts.
The oven door
The oven door has
does not open.
been locked by
the self-cleaning
The
H
symbol
function
lights up on the
display panel.
The display
The appliance has
been automati-
shows
.
"‰
cally turned off.
Error messages
When the indicator displays an error message with
the
sensor. The message will disappear. The set time
0
function will be deleted. If the error message does not
disappear, call the Technical Assistance Service.
The following error messages can be solved by the user.
Error message Possible cause Solution/advice
A sensor has
"‹‚‚
been pressed
for too long or
has got stuck.
The door lock
"‚‹‡
has been acti-
vated with the
door open.
The tempera-
"‚‚†
ture inside the
oven is too
high.
:
Risk of electrical discharge and the resulting shock.!
Incorrect repairs can be dangerous. Repairs can only be
carried out by qualified personnel from the Technical
Assistance Service.
14
Solution/advice
Check the condition of
the fuse/circuit breaker in
the fuse box.
Check that the light in the
kitchen and other house-
hold appliances are
working.
Set the time once again.
Turn the control knob
several times in both
directions.
Wait until the oven has
cooled and the
turns off.
.
x
Turn the function control
knob to the zero setting.
"
Press all the sensors one
by one. Check if a sensor is
stuck, covered or dirty
Press the
0
sensor. You
can now begin program-
ming again.
The door oven is locked
and heating has stopped.
Wait until the oven has
cooled. Press the
and reset the time.
Changing the oven bulb
If the oven light bulb is damaged it must be replaced. Special
25 W, E14, 220 V-240 V heat-resistant light bulbs (to 300 ºC
temperature) can be obtained from the Technical Support
Service or in specialist shops. Only use this type of bulb.
:
Risk of electrical discharge and the resulting shock.!
Disconnect the appliance from the mains. Ensure that this is
turned off.
Place a dishcloth into the cold oven to avoid damage.
1.
Remove the glass protection by unscrewing it to the left.
2.
Replace the bulb with a similar bulb.
3.
symbol
H
Screw the protection glass back into place.
4.
Remove the dishcloth and switch the oven back on at the
5.
mains.
Protective glass panels
Damaged protective glass panels must be replaced. Protective
glass panels cay be obtained from the Technical Assistance
Service. Please quote your appliance's product number and
, press
production number.
sensor
0
Hide quick links:
Advertisement
Table of Contents
