Installation - Yamaha BR250F Service Manual

C.
Installation
1. Grease the suspension where indicated in
the illustration.
2. Thoroughly grease the axle in the front
pivot arm. Tape the end caps in place.
This will hold the axle within the pivot
arm during installation of the suspen-
sion.
3. Place the suspension in the track, and
swing it into place in the chassis. Install
both front suspension-mounting bolts.
Do not tighten them at this point.
4-18
4. Grease the rear axle, and install it in the
rear pivot arm.
5. Install both rear suspension-mounting
bolts.
6. Tighten all four suspension-mounting
bolts, and torque them to specification.
Tightening torque:
4.5 rn-kq {33 ft-lb)
7. Place the torsion springs on their seats.
8. Adjust the track tension. {Refer to 4-9,
D "Track Adjustment."}