Brake Lever - Yamaha RX10GTX Owner's Manual

Control functions
1. Auxiliary DC jack cap
2. Auxiliary DC jack
NOTE:
After using the auxiliary DC jack, be sure to
remove the accessory power plug from the
jack and close the auxiliary DC jack cap.
ECS00120
CAUTION:
Do not use accessories requiring more
G
than the maximum rated capacity for the
auxiliary DC jack. This may overload the
circuit and cause the fuse to blow. (See
page 67 for the specified amperage.)
Do not use an automotive cigarette light-
G
er or other accessory with a plug that
gets hot because the jack can be dam-
aged.
Maximum rated capacity:
DC 12 V, 2.5 A (30 W)
ESU10560

Brake lever

The snowmobile is stopped by braking the en-
tire drive system.
Squeeze the brake lever towards the handle-
bar grip to stop the snowmobile.
20
1. Brake lever
NOTE:
When the brake lever is operated, the brake
light will illuminate.
ECS00060
CAUTION:
Make sure that the brake lever end does
not project out over the handlebar end.
This will help prevent brake lever damage
when the snowmobile is placed on its side
for service.
The brake lever is equipped with a position
adjuster.
To adjust the brake lever position:
1. Loosen the locknut.
2. While lightly pushing the brake lever in di-
rection (a), finger tighten the adjusting
bolt to set the brake lever to the desired
position.
1. Locknut
2. Adjusting bolt