Table of Contents
Advertisement
Control functions
1. "SELECT" button
2. "RESET" button
3. Display brightness level
3.
Turn the main switch to the on position,
and then, after 5 seconds, release the
"SELECT" button.
4.
Push the "RESET" button to select the
desired display brightness level, and then
push the "SELECT" button. The normal
display returns when the "SELECT" but-
ton is released.
NOTE:
If the main switch is turned to the off position
or the engine is started before completing the
procedure, the setting is not applied.
ESU10410
High beam indicator light "
The high beam indicator light comes on when
the high beams of the headlights are switched
on. (See page 19 for headlight beam switch
operation.)
1. High beam indicator light "
14
ESU10471
Low coolant temperature indi-
The low coolant temperature indicator light
comes on when the coolant temperature is
low and informs the rider that the snowmobile
should be warmed up. After the engine is
started, warm it up until the indicator light
goes off.
1. Low coolant temperature indicator light
The snowmobile can be operated normally af-
ter the indicator light goes off.
NOTE:
Operate the snowmobile at low speeds when
the low coolant temperature indicator light is
on. If the engine speed is too high, maximum
"
engine speed is reduced to protect the en-
gine.
ESU10441
Fuel meter, grip warmer level
compression damping level in-
dicator, and thumb warmer lev-
The fuel meter, grip warmer level indicator,
rear suspension compression damping level
indicator, and thumb warmer level indicator
have eight segments which show the amount
of fuel remaining in the fuel tank, the grip
warmer level or the thumb warmer level, and
"
cator light "
"
"
indicator, rear suspension
el indicator
"
Advertisement
Table of Contents
