Yamaha RX10GTX Owner's Manual page 49

1. Fastener
2. Right side cover
1. Fastener
2. Left side cover
To install a side cover
Place the side cover in the original position,
and then tighten the fasteners.
NOTE:
Be sure to fit the projection on the rear of the
side cover into the hole in the lower side cov-
er.
Top cover
To remove the top cover
1. Remove the screws, and then remove
the cable guide.
Periodic maintenance
1. Screw
2. Cable guide
2. Remove the bolts, disconnect the main
switch coupler and auxiliary DC jack cou-
pler, and then remove the top cover.
1. Bolt
2. Top cover
To install the top cover
1. Connect the main switch coupler and
auxiliary DC jack coupler, place the top
cover in the original position, and then in-
stall the bolts.
2. Pass all of the cables, etc., through the
cable guide, place the cable guide in the
original position, and then install the
screws.
EWS00090
WARNING
Do not drive the snowmobile with the
G
shroud or covers unfastened or re-
moved.
43