Mitsubishi Electric WD-60C10 Service Manual page 38

MODELS: WD-60C10 / WD-65C10 / WD-73C10 / WD-60638 / WD-65638 / WD-73638 /
WD-60738 / WD-65738 / WD-73738 / WD-82738 / WD-65838 / WD-73838 / WD-82838
Phase 3 - 4:3 and 16:9 Alignment
1. With the Manual Geometry Alignment activated, press <VIDEO> to enter the 4:3 Alignment Mode. The pat-
tern below will be displayed.
Note: Pressing <VIDEO> will toggle between the 4:3,16:9 (top & bottom) and 16 Point Geometry Alignment
modes.
2. In the 4:3 Alignment Mode, pressing (V43C & V43
cause the geometry pattern to be displayed with 11 preset amounts of correction. Toggle through them until
you find the one with the straightest Blue 4:3 Lines. It may help to count the patterns as you cycle through
them. When you find the pattern with the straightest Blue 4:3 Lines, press <VIDEO>. The Top 16:9 Align-
ment Mode will then be activated as indicated by the Top Red 16:9 Line displayed in the pattern.
3. In the Top 16:9 Alignment Mode, pressing (V43C & V43
< >) will cause the geometry pattern to be displayed with 15 different preset amounts of correction to the
Top Red 16:9 Line. Toggle through them until you find the one with the straightest Top Red 16:9 Line. Again,
count the patterns as you cycle through them. When you find the pattern with the straightest line, press
<VIDEO>. The Bottom 16:9 Alignment Mode will then be activated as indicated by the Bottom Red 16:9 Line
displayed in the pattern.
Select Straightest Red Line (Top)
<CH > or <CH
4:3 MODE
Select Straightest Blue Lines
<CH
4:3 MODE
Page 38
>) (V43+ & V43++ <
> or <CH >) (V43+ & V43++ <
> or < >) will
> or