Table of Contents
Advertisement
MODELS: WD-60C10 / WD-65C10 / WD-73C10 / WD-60638 / WD-65638 / WD-73638 /
WD-60738 / WD-65738 / WD-73738 / WD-82738 / WD-65838 / WD-73838 / WD-82838
V43C & V43 Manual Geometry Alignment
<MENU><2-4-7-0> "Calibration" <ENTER><1-3-9-7>
V43 & V43+ Manual Geometry Alignment
<MENU><2-4-5-7><0> "MANUAL GEOMETRY ALIGNMENT"<ENTER>
All Models
2. Manual Geometry Alignment
Note:
To remove all geometry correction, while the Geometry Alignment Pattern is displayed, press <1> then
<ENTER>. This will null all correction data. Then re-enter the Manual Geometry Alignment
Note: To restore the original factory geometry data from backup:
•
V43C & V43:
Exit the Service Menu and press <MENU><2-4-5-7><5-5-5-5>.
•
V43+ & V43++: From the Data Transfer & Geometry Menu <MENU><2-4-5-7><0>, select "RESTORE GE-
OMETRY DATA FROM BACKUP" <ENTER>.
Cursor +
+
Phase 1 - 16 Point Geometry Alignment
1. 16 Adjustment Points are indicated by white dots around the edge of the raster. The adjustment position is
indicated by a + cursor.
2. Starting from the upper left corner, use the <
flush with the bezel as a reference. See example above.
Note: Only the cursor will move. The Geometry Pattern will not change.
3. After adjusting each point, use the (V43C & V43
the next point clockwise and repeat until all 16 points have been adjusted.
4. After all 16 points are adjusted and the cursor is returned to the original starting point, press <ENTER>.
Correction will be automatically calculated and saved and the Manual Geometry Alignment will be terminated.
5. Re-activate the Manual Geometry Alignment. The geometry pattern will appear with the corrections applied. If
Geometry is acceptable, press <EXIT> to quit. To touchup the raster geometry, proceed to Phase 2.
Phase 2 - Geometry Touch-up Alignment
1. If additional correction is necessary after performing the Manual Geometry Alignment, re-enter the Manual
Geometry Alignment mode.
2.
Use the (V43C & V43
the point needing correction.
3.
Use the <
> buttons to indicate the direction and amount of correction necessary at the particular
point. Note: Only the cursor will move. The Geometry Pattern will not change.
4.
Press the <INFO> button to apply the correction. The Geometry Pattern will now show the correction.
5.
Repeat steps 2, 3 and 4 as needed.
6.
Press <ENTER> to save your changes. The Manual Geometry Alignment will be terminated.
7.
Press <EXIT> to exit the alignment mode. Or, to proceed to Phase 3, re-enter the Geometry Alignment
mode
Align Cursor + Flush With Bezel Edge
<CH
<CH
> or <CH
>)
(V43+ & V43++ <
Page 37
> buttons to align the + at each point in a straight line,
>)
(V43+ & V43++ <
> or <
>) button to shift the cursor to
mode.
Adjustment Points
(16 Total)
>) button to shift the cursor to
Hide quick links:
Advertisement
Table of Contents
