Operating Instructions - Chicago Electric 42864 Assembly And Operation Instructions Manual

Note: For additional information regarding the parts listed in the following pages, refer to
the Assembly Diagram at the end of this manual.
cAutION: Always make sure the Power Cord (17) of the Sander is unplugged from
1.
its electrical outlet prior to making any adjustments to the tool.
2. Clamp your workpiece down, or insert it in a vise. Make sure the wood you are
sanding does not have any nails or metal of any kind in it, or you will ruin the sand-
paper and damage the Pad (28).
3. After donning the appropriate safety gear covered on page 2 of this manual, plug
in the Sander.
4. Turn on the Sander by turning on the Switch (2).
5. Always run the Sander for a few seconds before contacting the workpiece.
6. Contact the workpiece with minimal pressure. If the Sander is not removing enough
material, try a grittier piece of sandpaper. If you want to remove a lot of material
fast, use a belt sander.
Note: All orbital sanders leave sanding marks on the workpiece. To minimize sanding
marks, always try to sand with the grain of the wood.
7. Occasionally check the sandpaper for tears, wear, or fraying. Replace if neces-
sary.
8. When you are finished, turn off the Switch (2).
For technical questions, please call 1-800-444-3353.
SKU 42864

OpERAtING INStRuctIONS

Page 10