Page 1
. All Rights reserved. No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools. For Technical Questions and replacement parts, please Call 1-800-444-3353 Please visit our WebSite www.harborfreight.com...
6. Protect Your Eyes, Ears, and Lungs. face mask if you are producing metal filings or wood chips. Wear hearing protection during ex- tended periods of operation. Safety equipment is available at Harbor Freight Tools. 7. Stay Alert. Concentrate on what you are doing. Use common sense. Do not operate while under the influence of drugs or alcohol.
Do not use the tool for a purpose for which it was not intended. 17. Replacement Parts And Accessories. or accessories. Approved parts and accessories are available at Harbor Freight Tools. Voltage Warning Before connecting any power tool to a power source (receptacle, outlet) make sure the voltage supplied is the same as specified on the name plate on the tool.
Page 4
Carefully inspect the condition of the accessory before use and check the accessory continually during use. If any damage is noted, stop immediately and replace the accessory with an undamaged one. Harbor Freight Tools cannot be held responsible for damage caused by using a damaged accessory on this tool.
Figure 3 15 to 25 Degrees To use this tool as a sander refer to Figure 1 under ASSEMBLY directions on page four. Follow the same directions, substituting the Sanding Disc for the Polishing Wheel (#46). Do not use the entire Sanding Disc surface on the workpeice. The inner edge of the disc should be used at a 15 to 25 degree angle as shown in Figure 3.
2. Inspect the carbon Alternation Switch (#22) every six months. If it looks worn, have it replaced by an authorized service representative. 3. Keep any liquid materials away from the motor. 4. After repeated use, Wool Bonnets will wear. Purchase new Wool Bonnets at Harbor Freight Tools. # 41213 Part Name...