Advanced Access Point Settings For Wlan; Connect Pc To Web - Nokia E71 User Manual

Connection name
•
for the connection.
Data bearer — Select
•
WLAN network name
•
set identifier (SSID), that is, the name that
identifies the specific WLAN, select
manually. To select the network from the
WLANs in range, select
Network status — Select
•
network you are connecting to is hidden or
Public if it is not hidden.
WLAN network mode
•
Infrastructure, devices can communicate with
each other and with wired LAN devices through
a WLAN access point. If you select Ad-hoc,
devices can send and receive data directly with
each other, and no WLAN access point is needed.
WLAN security mode
•
same security mode that is used in the WLAN
access point. If you select WEP (wired equivalent
privacy), 802.1x, or WPA/WPA2 (Wi-Fi protected
access), you must also configure the relevant
additional settings.
WLAN security settings
•
settings for the selected security mode.
Homepage — Enter the web address of the
•
page you want to display as the home page
when you use this access point.
To set up a WLAN access point automatically, use the
WLAN wizard. Select Menu
wiz..
— Enter a descriptive name
Wireless LAN.
— To enter the service
Enter
Search for networks.
Hidden if the
— If you select
— You must select the
— Edit the security
Connectivity WLAN
> >
Advanced access point
settings for WLAN
Select Menu Tools
> >
Access points.
After setting up a basic access point for WLAN, select
Options Advanced settings, and define the
>
following advanced settings:
IPv4 settings — Enter the device IP and name
•
server addresses for the IPv4 internet protocol.
IPv6 settings — Select or enter the name server
•
addresses for the IPv6 internet protocol.
Ad-hoc channel — The channel is usually chosen
•
automatically. To enter the channel number (1-11)
manually, select User
Proxy server address
•
address.
Proxy port number — Enter the proxy server port
•
number.

Connect PC to web

You can use your device to connect your PC to the web.
1. Connect the data cable to the USB connectors of
your device and your PC.
2. Select Connect PC to
is automatically installed from your device to the
PC.
3. Accept the installation in your PC. If asked, accept
also the connection. When the connection to the
Settings Connection
>
defined.
— Enter the proxy server
web. The necessary software
>
71