Connecting An Adat Or Other Lightpipe Machine - Tascam TM-D1000 Tutorial

TASCAM DA-45HR
1) Connect a TDIF cable
from the TDIF1-A port of
the TM-D1000 to the IF-
TAD.
2) Connect optical cables
from the optical in of the
IF-TAD to the out of the
ADAT, and from the out of
the IF-TAD to the in of the
ADAT.
3) Connect a BNC to RCA
cable from the Word Clock
out of the IF-TAD to the
Word Sync in of the TM-
D1000.
4) Select the digital input
on your multitrack. For an
ADAT, push "Digital In" or
"Digital Input" (depending
on the vintage) of your ADAT. For other lightpipe
machines, consult that machine's manual for settings.
5) Connect a balanced cable from your monitor
outputs (not your stereo outputs) to the power
amplifier for your monitor speakers.
1/99
Section III, Continued
Connecting an ADAT
or other Lightpipe machine
IF-TAD
Section III, page 2
TASCAM PA-150 DUAL POWER AMPLIFIER
MMC/
SYNC
TASCAM
TM-D1000
8) The mixdown deck will return through EXT
INPUTS. Both balanced and unbalanced connections
are provided.
9) If you have an MMC to ADAT sync box, consult
that unit's manual for hook-up instructions and
settings.
6) If you have a mixdown
deck with a digital input,
connect your mixdown
deck to Digital Output A.
Both SPDIF and AES/EBU
connections are available.
Be sure to set your digital
format to the appropriate
format.. (For instructions,
see Section VIII -
AES/EBU and SPDIF
in/out.)
7) If your mixdown deck
only has analog inputs,
connect the Stereo Output
of the TM-D1000 to the
input of your mixdown
deck. Both balanced and
unbalanced connections
are provided.
TASCAM TM-D1000 Tutorial