Panasonic SC-PM22 Operating Instructions Manual page 20

2
1
OPEN
2
REV MODE
3
∫
4
OPEN/CLOSE
5
¥/¥;
REC/REC PAUSE
RQT5243
5
1 2 3 4
5 6 7 8
9 10 11 12
13 14 15
Tape direction
1 2 3 4
5 6 7 8
9 10 11 12
13 14 15
1 Tracks are recorded in the order in which they are found on the CD.
Tracks are cut in the middle when the end of the tape is reached.
You can record from any point on the tape.
3
Press [
Close the holder by hand.
4
Tape direction is automatically set to "
Press [REV MODE] on the remote control to
select the reverse mode.
Each time you press the button;
: One side is recorded, then recording stops auto-
matically.
, : Both sides (front side
then recording stops automatically.
Press [ ] to select the CD mode.
Press [
Insert the CD with label facing upward.
Press [ OPEN/CLOSE] to close the CD tray.
Press [ /
FWD
recording.
If you selected "
change to "
The recording will start from the first track.
FWD
To stop recording
To add a 4 second silent interval before stopping
Press [ ] on the CD control section.
The CD will stop and the cassette deck will go into the recording
standby mode.
To cancel the recording standby mode, press [ ] on the cassette
FWD
deck control section.
To stop recording without a silent interval
Press [ ] on the cassette deck control section.
The recording will stop and the CD will go on.
To stop recording temporarily
Press [ / REC/REC PAUSE].
FWD
To resume recording, press [ /
To record on reverse side
Before recording, press [
The tape direction will be shown as "
To record from a specific point on a tape
Before recording, advance the tape to the point from where you want
to start recording.
FWD
REC
1. After step , program the track(s) you want (
page 15).
2. Press [ /
OPEN] and insert the tape.
".
reverse side) are recorded,
OPEN/CLOSE] to open the CD tray.
REC/REC PAUSE] to start
" in step , the direction will automatically
" when recording starts.
REC/REC PAUSE].
] twice and immediately thereafter [ ].
".
REC/REC PAUSE] to start recording.
steps – on