Panasonic SC-PM22 Operating Instructions Manual page 11

3
1
2
1
TUNER/BAND
2
TUNE MODE
3
TUNE/TIME ADJ
DOWN/∂ ∂ UP/µ µ
4
MEMORY
Preset channel
4
TUNED ST
M
TUNED ST
3
Up to 15 stations can each be set in the FM and AM bands automat-
ically.
If broadcast frequencies are preset in the memory, you can easily
tune in any of these frequencies from the unit or remote control.
You can also preset just those stations you like.
(See "Presetting only your favorite stations" below.)
Preset each station in the FM and AM bands with the following
procedure.
Press [TUNER/BAND] to select "FM" or "AM".
The power will come on automatically.
The glide panel retracts enabling access to the operation
buttons.
Each time you press the button; "FM"
Press [TUNE MODE] to select "MANUAL".
Each time you press the button; "MANUAL"
Turn [TUNE/TIME ADJ] to the right or left until
the display shows the frequency from which
you want to begin automatic memory preset-
ting.
Tips on tuning in radio stations
Turn and hold [TUNE/TIME ADJ] to the right or left until the
frequency starts scrolling.
Continue to hold [TUNE/TIME ADJ].
When nearing the desired frequency, partially turn [TUNE/
TIME ADJ] to stop scrolling and then fine tune the broadcast
with slight adjustments to the right or left.
Press and hold [MEMORY] until the frequency
begins to change.
This will start presetting automatically. When finished, the radio
will tune in last station memorized.
If the above is not possible for some reason, do the following.
Preset the stations one at a time.
1. Perform step , then press [MEMORY].
2. Select a station with [TUNE/TIME ADJ], and press [MEMORY].
"M" will flash on the display.
3. While "M" is flashing, select a preset channel with [TUNE/TIME
ADJ] and press [MEMORY] again. "M" will go out and the station
will be stored in memory.
Memory retention
Your preset frequencies are retained in memory for about 2 weeks
while the system is unplugged.
"AM".
"PRESET".
RQT5243