Panasonic SC-PM22 Operating Instructions Manual page 10

A
B
2
3
1
1
H/I
POWERH/I
2
CLOCK/TIMER
3
A
DOWN/∂ ∂
CLOCK/TIMER
B
RQT5243
AUTO OFF
AUTO OFF
For United Kingdom
For Australia and N.Z.
TUNE/TIME ADJ
UP/µ µ
When CD or tape is selected as the source.
To save power the unit turns off if it is left unused for four minutes.
Note
This function does not work if the source is tuner or AUX.
Press [AUTO OFF].
"AUTO OFF" is shown on the display.
FWD
To cancel
Press [AUTO OFF] again to clear "AUTO OFF" from the display.
For your reference
The setting is maintained even if the unit is turned off. When the unit
is turned on again, "AUTO OFF" is displayed and the unit functions as
described above.
"AUTO OFF" disappears from the display if either tuner or AUX is
selected as the source. It comes on again when you select CD or
tape.
This is a 24-hour display clock.
This example in the figure shows how to set the time for 18:25.
Press [ /I] to turn the unit on.
The glide panel retracts enabling access to the operation
buttons.
Press [CLOCK/TIMER] to select "CLOCK".
Each time you press the button;
CLOCK PLAY
Original display
(within 7 seconds or so)
Turn [TUNE/TIME ADJ] to the right or left to
show the present time.
Press [CLOCK/TIMER] to finish setting the
time.
The display will return to the previous display setting after about
4 seconds.
To display the time
To check
Press [CLOCK/TIMER] to select "CLOCK".
The time will be displayed for about 5 seconds and then the display
will return to whatever was previously displayed.
To display the time continuously
Press [DISPLAY] to select present time.
Each time you press the button:
Present time
Original display
For your reference
If the time has been set, the display will default to present time when
in standby mode.
REC
Tape counter