Sony WEGA KE-50XBR900 Operating Instructions Manual page 22

Install the display unit using an optional stand or rack unit.
For details, refer to the operating instructions supplied with your stand or rack unit.
Connect the other end of display interface cable to the Media receiver unit's
DISPLAY SIGNAL OUT jack, and connect the AC power cord (supplied) to the
media receiver unit's AC IN jack.
@@@@®2 _,_°"_ I I=L=_731 .... M
- Ti0htoothesoro s,o ,,uot,,
the screw is stabilized, u]_.u, j
Display interface AC power cord
cable (supplied) (supplied)
After making all connections, connect the AC power cords (supplied) to wall
outlets.
Be sure to use the supplied AC power cords.
When connecting optional components, do not connect the AC
power cords to wall outlets until you have completed making all
connections.
Do not tighten the screws too much. It may damage the screws.
Handle the display interface cable with care. If you pull the
cable by catching your feet on the cable, this unit may fall and
cause injury.
Do not use damaged cables, such as cables whose connectors
are deformed.