Vcr And Cable Box - Sony WEGA KE-37XS910 Operating Instructions Manual

VCR and Cable Box
Your cable company scrambles some channels, such as prelnium
channels (which requires you to use a cable box), but does not scramble
all channels.
With this connection, you can use all the dual picture features.
i iiii
Use the TV remote control to change channels coming through the cable
box. (You must first pro_aln the remote control t\_r your specific cable
box; see "Pro mamlning the Remote Control" on page 52.)
Use the TV remote control to change channels coming directly into the
TV's VHF/UHF jack. (The TV's tuner provides a better signal than the
cable box.)
Record channels coming through the cable box and channels coming
directly into the TV.
A splitter, which is a small, inexpensive device that you can purchase at
your local electronics store.
Three coaxial cables.
One A/V cable or one S VIDEO cable with audio cables.
ii i
Connect the CATV cable to the single (input) jack of the splitter.
Use the supplied antenna cable to connect one of the splitter's two
output jacks to the lV's VHF/UHF jack.
Use a coaxial cable to connect the splitter's other output jack to the
cable box's input jack.
Use a coaxial cable to connect the cable box's output jack to the VCR's
RF input jack.
Use an A/V cable to connect the VCR's A/V output jacks to the TV's
A/V input jacks.
Run the Auto Setup program, as described in "Setting Up the Channel
List" on page 48.
_=_ Using S VIDEO jacks? See page 29.