Troubleshooting; Electronic Error Codes; Hesitation Of The Belt; Drive Belt Tension Adjustment - PaceMaster ProPlus II Owner's Manual

Electronic Error Codes

Your self-diagnostic ProPlus

detects a problem, an error code will be displayed. If an error code appears during operation of your treadmill, do the following:

•

Make a note of the error code number.

•

Obtain your serial number, located on the front of the treadmill approximately 10-12 inches to the left of the power cord.

•

Write down which mode of operation you were using, the speed and incline that were set and if you were pressing any

buttons at the time.

•

Contact the PaceMaster dealer where you purchased your treadmill. If you have moved or need the name of the local dealer,

visit our website at

information.

Hesitation of the Tread belt

Hesitation of the tread belt usually indicates slippage of either the tread belt (the belt you walk on) or the drive belt (the belt connecting the

drive roller to the motor). To determine which of these belts is slipping, first adjust the drive belt tension and test to see if the slippage stops.

If the hesitation is not corrected than the tread belt tension needs adjustment.

CAUTION:

The power must be turned off before making adjustments.

Drive Belt Tension Adjustment

Step One:

Use a Phillips head screwdriver to remove the 2 screws

that hold the front of the motor cover in place and remove

the motor cover.

Step Two:

Locate the four motor mount screws (1) as shown in the

diagram and loosen them each two turns each using the 3/16"

allen wrench.

Step Three:

Locate the drive belt adjustment screw (2) in the lower

front end of the treadmill. Insert the allen wrench into the drive

belt adjustment screw. Turn the screw 1/2 turn clockwise.

Step Four:

Complete the adjustment by tightening the four motor mount

screws (1).

Step Five:

Walk on the treadmill to determine if the slippage is decreased

or eliminated.