Panasonic SC-HT1500 Operating Instructions Manual page 17

Removing Interference
≥When connecting to a television with RF socket only
( page 12)
TV screen
Picture with interference
In some cases, interference (lines or patterning) or a very poor
picture may appear on the TV screen when this unit is connected.
Follow the steps below to change the video playback channel (RF
output channel) to remove the interference.
1
Press [FUNCTIONS] for more than 5
seconds.
Unit's display
RF output channel number appears.
TV screen
RF OUTPUT CHANNEL
DVD
CH :
SELECT
ENTER
Test pattern screen appears.
2
Press [W X CH] to select a channel
number, which differs by 2 or 3 from
the present channel number.
e.g. If the original channel number was 28, enter 31.
The test pattern screen disappears.
3
Re-tune your TV until you receive the
test pattern screen.
RF OUTPUT CHANNEL
CH :
SELECT
ENTER
If you can't see the test pattern screen clearly, repeat step 1
and 2 to select RF output channel again.
4
Press [ENTER] to finish this setting.
Clear picture
28
RETURN
DVD
31
RETURN
VIDEO Plusr numbers for Satellite/
Cable TV stations
This unit doesn't recognise VIDEO Plusr numbers for Satellite
stations or Cable TV stations.
The following operation also allows you to use VIDEO Plusr
numbers to make timer recordings for satellite and cable TV
stations. As the settings indicated below are dummy timer
recordings, delete them in step 6.
Preparation
Turn on the Satellite receiver(s) or Cable TV box.
Select a correct station.
1
Press [VIDEO Plus+].
VIDEO Plus +
Remain HDD 30:24 SP DVD
12:53:00 15. 7. TUE
Enter VIDEO Plus+ Number by using 0-9 keys.
2
Press the numbered buttons to enter
a VIDEO Plusr number for a satellite
station (e.g. Sky One) or Cable TV
station.
Press [2] to move back to correct a digit.
3
Press [ENTER].
"-- ---" will appear under "Name".
TIMER
Remain HDD 30:24 SP
RECORDING
12:54:00 15. 7. TUE
Name Date Start Stop Mode
15/ 7 TUE 19:00 20:00 SP
Programme Name
4
Press [3, 4] to select the channel or
AV input that is to be used for
recording from the satellite station or
Cable TV station.
5
Press [ENTER].
The channel or AV input corresponding to the VIDEO Plusr
number is memorised.
TIMER
Remain HDD 30:24 SP DVD
RECORDING
12:55:00 15. 7. TUE
No. Name Date Start Stop Mode
PDC
01 AV2 15/ 7 TUE 19:00 20:00 SP OFF
New Timer Programme
Repeat steps 1s5 above until you have set dummy timer
recordings for each of the satellite stations or Cable TV
stations that you will make VIDEO Plus+ recordings from.
6
Press [3, 4] to select each
programme that you have just set
and press [¢ CANCEL] to delete it
from the timer recording list.
To exit the screen
Press [RETURN].
1:58 SP
DVD 1:58 SP
HDD
PDC DVD
OFF HDD
1:58 SP
HDD Disc
space
DVD
OK
RQT7621
17