Wolf 762 Installation Instructions Manual page 4

W O L F
B E F O R E
Proper installation is your responsibility.
Installations must be performed by a
qualified or licensed contractor, plumber or
gas fitter, qualified or licensed by the state,
province or region where this appliance is
being installed. You must also ensure that
electrical installation is adequate and
conforms with all local codes and
ordinances.
Wolf dual fuel ranges are manufactured for
use with natural gas or LP gas. Please
check product rating plate for type of gas
needed.
Proper gas supply must be available; refer
to Gas Supply Requirements on page 13.
Electrical ground is required; see Electrical
Requirements on page 15.
Check the location where the range will be
installed. The location should be away from
strong draft areas, such as windows, doors
and strong heating vents or fans. Do not
obstruct the flow of air. The area in which
you are installing this appliance must have
an adequate supply of fresh air to ensure
proper combustion and ventilation.
Make sure you have everything necessary
for proper installation. It is the responsibil-
ity of the installer to comply with the instal-
lation clearances specified on the product
rating plate. The rating plate is located at
the far right of the bottom of the control
panel assembly just above the oven door.
All openings in the wall or floor where the
range is to be installed must be sealed.
When installing the range under existing
cabinets where the installation does not
meet the minimum cabinet clearances,
install a ventilation hood or other non-
combustible surface above the range to
avoid burn hazards. Refer to Minimum
Clearances on page 6.
4
D UA L F U E L R A N G E S
Y O U S TA R T
C O M M O N W E A LT H O F M A S S A C H U S E T T S
Installations and repairs must be performed
by a qualified or licensed contractor,
plumber or gasfitter qualified or licensed by
the state, province, or region where this
appliance is being installed.
Only use gas shut-off valves approved for
use within the state, province, or region
where this appliance is being installed.
A flexible gas connector, when used, must
not exceed 3' (.9 m).