Wolf 762 Installation Instructions Manual page 12

W O L F
OV E N D O O R
Failure to insert the hinge pin in the
appropriate hinge arm will cause damage
to the range. Minor injuries may occur.
IMPORTANT NOTE: The oven door(s) should
not be removed unless it is necessary to fit the
range through a tight doorway. Door removal
should only be done by a qualified service
technician or installer. Door removal and rein-
stallation may cause damage to the oven
porcelain interior.
If removal of the oven door(s) is necessary, a
hinge pin, supplied with the range, will need to
be inserted in the appropriate hinge arm. For
each oven door, only one hinge arm is spring
loaded, requiring use of the hinge pin for
removal of the oven door. The hinge pin will
be found taped to the inside of the oven door.
For 30" (762) and 36" (914) ranges, the hinge
pin will be inserted through the hole in the
right hinge arm (facing the unit). On 48" (1219)
and 60" (1524) ranges, the spring hinges are
located on the outer edges of the unit. On
these units, the left oven door will have the
spring hinge on the left side and the right oven
door will have the spring hinge on the right
side. Refer to the illustrations below for the
location of the spring hinge(s) for your model.
Place Hinge Pin on
Spring Hinge Side of Door
Spring hinge location for 30" (762)
and 36" (914) ranges.
12
D UA L F U E L R A N G E S
R E M O V A L
Place Hinge Pins on
Spring Hinge Side of Door
Spring hinge locations for 48" (1219)
and 60" (1524) ranges.
If removal of the oven door(s) is necessary,
follow these steps:
1) Remove the lower kickplate assembly to
access the lower hinge retainer mounting
screws.
2) Open the oven door to its fully opened
position and remove both upper and lower
hinge retainer mounting screws. NOTE: The
oven gasket may have to be moved slightly
to access the bottom screws.
3) After removing the mounting screws, move
the hinge retainer plate forward slightly.
NOTE: The hinge retainer plate will remain
on the door hinge assembly after the
mounting screws have been removed.
4) Insert the supplied door hinge pin through
the hole in the appropriate hinge arm. Refer
to the illustration below.
5) Carefully close the oven door to about a
60° angle from horizontal and lift the door
away from the oven. NOTE: A slight racking
motion may be required for removal.
6) For 48" (1219) and 60" (1524) ranges,
complete these steps for both oven doors.
Do not lift or carry the oven door by the
door handle.
Hinge
Retainer
Plate
Hinge
Pin
Kickplate
Oven door removal
Upper Mounting
Screw