Wolf 762 Installation Instructions Manual page 11

I N S TA L L AT I O N I N S T R U C T I O N S
U N PAC K T H E R A N G E
Remove and discard all packing materials,
including cardboard and tape on the outside of
the range and inside the oven cavity.
Remove the box containing the oven racks,
oven rack guides and broiler pan from inside
the oven cavity. Be sure to do this for both
oven cavities on the 60" (1524) range.
Remove the burner grates and styrofoam off
the top cooking surface. Be sure to remove the
burner caps packaged in styrofoam below the
burner grates.
Do not discard the angle iron supplied with the
range. This is the anti-tip bracket and must be
installed with the unit. Refer to Anti-Tip Bracket
Installation on page 16.
Carefully lift the range off the pallet and
remove the styrofoam from the bottom of the
unit.
The dual fuel range is very heavy. Use
caution when lifting and moving the unit.
Secure oven door(s) closed before
moving the unit.
1
Casters allow for 2 / " (54)
8
height adjustment
Rolling Casters
Dimensions in parentheses are in
millimeters unless otherwise specified.
Do not lift the range by the oven door
handle(s). This will damage the oven door
and hinges.
IMPORTANT NOTE: Before moving the range
into position, protect any finished flooring with
appropriate materials to avoid damage to the
floor.
The rear of the range has rolling casters which
allows for easy movement of the range by
picking up on the front of the unit. Refer to the
illustration below.
The dual fuel range comes from the factory at
7
an overall height of 35 / " (911) from floor to
8
the top of the bullnose, before any height
adjustment. The legs and casters allow for
1
2 / " (54) height adjustment. Refer to the
8
3
illustration below. Use a /
4
the rear casters. Refer to the Installation Speci-
fications illustration for your model on pages
7–10 for additional dimensions.
" socket to adjust
11