Table of Contents
Advertisement
PART 1 • English
2.0 CONNECTION
2.1 Connecting to Terrestrial Antenna
To receive the broadcast signal, the terrestrial antenna cable should be connected to the ANT IN connector at
the back of the receiver. Connect the LOOP OUT to the LOOP IN with the short RF-Coax cable.
2.2 Connecting to TV with SCART cable
Connect the TV set to the TV SCART connector of the receiver through a SCART cable.
2.3 Connecting to Video/DVD Recorder with SCART cable
This terrestrial receiver may also be operated together with a Video or DVD recorder..
Connect your Video/DVD Recorder through a SCART cable on VCR SCART.
The signals from Video/DVD Recorder will pass to your TV-set if this terrestrial receiver is powered off or
the AV button on remote control is pressed.
Optional: using coaxial cable, connect TO TV output of the receiver to aerial input of your VCR and aerial
output of VCR to aerial input of your TV set. This will allow you to watch and record analogue
aerial programs to your VCR.
2.4 Connecting to TV with S-VIDEO cable
On the back of your receiver you will find the S-VIDEO connector. Install an S- VIDEO cable between
connector of the receiver and the one of your TV set. This S-VIDEO output is connected to the same
tuner as TV SCART.
NOTE: This output supports only video. Please set to S-VIDEO in menu System settings > Video
Output. If RGB mode is selected this output is not active.
2.5 Connecting to a Digital Audio Amplifier
Connect your Digital Audio Amplifier with the S/PDIF connector on the back of the receiver.
2.6 Connecting to PC
onnect the RS-232 connector of the receiver to the PC by using a serial cable. This allows you to
download new versions of software to your receiver.
Fig. 1
Fig. 1
Fig. 1
Fig. 3
Fig. 4
Fig. 5
5
Advertisement
Table of Contents
