Table of Contents
Advertisement
Symptom
Audio & video issues
TV Picture changes
colour
Blocks in the TV picture
A.2 SPECIFICATIONS
Demodulator
Demodulator:
Transmission mode:
Video Decoder
Profile level:
Video resolution:
Decoding & Video Out:
Aspect ratio:
Audio Decoder
MPEG MusiCam Layer I & II
Sampling rate:
Audio mode:
Tuner
Front End:
Input frequency range:
Loop through frequency range:
Input signal level:
Memory and System
Flash memory:
SDRAM:
16
Remedy
This may happen after a power-cut or disconnection from the power source.
Your receiver has lost some software settings. Switch off your receiver and
on again after a few seconds. If the problem persists, contact your vendor.
The signal is too weak or defective due to e.g. bad weather conditions. Try to
adjust your aerial position or wait for the signal to be re-established.
COFDM; 16 QAM/64 QAM
2 K ~ 8 K
MPEG-2 MP@ML
720 x 576 pixels (PAL), 720 x 480 (NTSC)
PAL & NTSC
4:3, 4:3 FULL, 16:9
32, 44.1, 48 kHz
Stereo, Joint Stereo, Dual Mono
DVB-T, UHF & VHF Tuner
174 ~ 470 MHz (VHF) and 470 ~ 862 MHz (UHF)
47~862 MHz
-82 ~-20 dBm
2 x 1 MByte
8 MByte
PART 1 • English
Advertisement
Table of Contents
