Table of Contents
Advertisement
1.0 INSTRUCTION
1.1 Safety Instructions
DO NOT INSTALL YOUR RECEIVER:
In a closed or poorly ventilated cabinet; directly on top of or under any another equipment; on a
n
surface which might obstruct the ventilation slots
DO NOT EXPOSE THE RECEIVER OR ITS ACCESSORIES:
To direct sunlight or near any other equipment that generates heat; to rain or intense moisture;
n
to intense vibration and to any shock which may cause permanent damage to your receiver or to
any magnetic objects, such as loudspeakers, transformers, etc.
Do not use a damaged power cord. It may cause a fire or an electrical shock. Do not touch a
n
power cord with wet hands. It may cause an electric shock
Never open the cover. It is dangerous to touch the inside of the receiver due to high voltage
n
currents and possible electrical hazards. Your warranty will be void if the receiver has
been opened
When the receiver is not used for a long period of time, you should unplug the power cord from
n
the wall socket
Do not use alcohol or ammonia based liquids to clean the receiver. If you wish, you may clean
n
your receiver with a soft lint-free cloth slightly made damp with a mild soap solution, only after
disconnecting from the mains voltage supply. Make sure no foreign objects fall through the
ventilation slots because this could cause fire or an electric shock
Do not place any objects on top of the receiver because this might prevent proper cooling of the
n
components inside
SAFETY PRECAUTIONS
Do not open the receiver cover, as you will be exposed to a shock hazard. It will also void your
n
warranty. Refer all maintenance or servicing to suitably qualified personnel
When you are connecting the cables, be sure that the receiver is disconnected from the mains
n
supply voltage. Wait a few seconds after switching off the receiver before you move the receiver
or disconnect any equipment.
It is a necessity that you only use an approved extension and compatible wiring that is suitable
n
for the electrical power consumption of the installed equipment. Please ensure that the electrical
power supply corresponds with the voltage on the electrical identification plate at the back of
the receiver
If the receiver does not operate normal even after strictly following the instructions of this user manual, it
is recommended to consult your dealer.
2
PART 1 • English
Advertisement
Table of Contents
