First Time Installation - Strong SRT 5220 User Manual

EPG Shows the EPG (Electronic Program Guide) during No-menu state only
Channel selection
0 ~ 9
MOSAIC Show pictures up to 9 channels on the screen( depends on Broadcaster support)
AV Toggle between TV and AV mode

4.0 FIRST TIME INSTALLATION

Make sure your terrestrial receiver is connected correctly to your TV and terrestrial antenna and the
signal quality is good enough. Confirm the power plug of the receiver is plugged into the wall outlet. Turn
on the receiver.
It is recommended to perform the first time installation following the Installation Wizard step by
step. This will help you to easily achieve system configuration and channel installation. If you are a
professional installer then you can skip the wizard by pressing EXIT button and set-up the channels using
the Channel Search menu.
1. You are asked to Select a Language out of the list.
Press UP/DOWN to choose your language, press OK to confirm.
2. The Preference Menu will appear.
Please select your Country, Antenna Power mode and Channel numbering. Press UP/DOWN to
select the items, press RIGHT/LEFT to change the value of the item. If you choose BACK, it
will go back to the previous menu screen. Press OK to confirm.
3, You enter the Adjust antenna menu.
Press LEFT/ RIGHT to select Channel No, adjust your antenna direction and position (if
necessary) to get maximum levels on the signal level and quality indicators. You can check
with your dealer on which channels digital terrestrial broadcast is available at your location.
Move cursor to Scan, press OK to confirm, The Automatic Search screen will appear. On
completing the search, the receiver will save services information automatically and exit to
normal play state.
8
PART 1 • English