Inserting And Removing The Card (Optional)/The Battery - Panasonic LUMIX DMC-FX500 Operating Instructions Manual

Inserting and Removing the Card (optional)/the
Battery
•
Check that this unit is turned off.
•
We recommend using a Panasonic card.
1
Slide the release lever in the direction of
the arrow and open the card/battery door.
•
Always use genuine Panasonic batteries
(DMW-BCE10E).
•
If you use other batteries, we cannot guarantee
the quality of this product.
2
Battery: Insert it fully being careful about
the direction you insert it. Pull the lever
A in the direction of the arrow to remove
the battery.
Card: Push it fully until it clicks being
careful about the direction you insert it.
To remove the card, push the card until it
clicks, then pull the card out upright.
B: Do not touch the connection terminals of the
card.
•
The card may be damaged if it is not fully inserted.
3
1: Close the card/battery door.
2: Slide the release lever in the direction
of the arrow.
•
If the card/battery door cannot be completely
closed, remove the card, check its direction and
then insert it again.
Note
•
Remove the battery after use. Store the removed battery in the battery carrying case
(supplied).
•
Do not remove the battery until the LCD monitor and the status indicator (green) turn off as the
settings on the camera may not be stored properly.
•
The supplied battery is designed only for the camera. Do not use it with any other equipment.
• Before removing the card or battery, turn the camera off, and wait until the status indicator has
gone off completely. (Otherwise, this unit may no longer operate normally and the card itself
may be damaged or the recorded pictures may be lost.)
Preparation
A
B
17
VQT1Q48