Panasonic LUMIX DMC-FX500 Operating Instructions Manual page 124

Others
The motion pictures cannot be played back on a TV.
•
Are you trying to play back the motion pictures by directly inserting the card in the card slot of the TV?
> Connect the camera to the TV with the AV cable (supplied), or with the component cable
(DMW-HDC2; optional), and then play back the motion pictures on the camera. (P107, 108)
The picture is not displayed fully on the TV.
> Check [TV ASPECT] setting. (P28)
The picture cannot be transferred when the camera is connected to a PC.
•
Is the camera connected to the PC correctly?
•
Is the camera recognised by the PC correctly?
> Set to [PC] in [USB MODE]. (P27, 101)
The card is not recognised by the PC. (The built-in memory is recognised.)
> Disconnect the USB connection cable. Connect it again while the card is inserted in the
camera.
The picture cannot be printed when the camera is connected to a printer.
•
Pictures cannot be printed using a printer which does not support PictBridge.
> Set to [PictBridge(PTP)] in [USB MODE]. (P27, 103)
The ends of the pictures are cut at printing.
> When using a printer with a trimming or borderless printing function, cancel this function
before printing. (For details, refer to the operating instructions for the printer.)
> When you order photo studios to print pictures, ask the photo studio if the pictures can be
printed with both ends.
An unreadable language was selected by mistake.
> Press [MENU/SET], select the [SETUP] menu icon [
the desired language. (P29)
A red lamp sometimes turns on when the shutter button is pressed halfway.
•
In dark places, the AF assist lamp (P79) lights red to make it easier to focus on a subject.
The AF assist lamp does not turn on.
•
Is [AF ASSIST LAMP] on the [REC] mode menu set to [ON]? (P79)
•
The AF assist lamp does not turn on in bright places.
The camera becomes warm.
•
The surface of the camera may become warm during use. This does not affect the performance
or quality of the camera.
124
VQT1Q48
Others
] and then select the [~] icon to set