The area around where the pictures were taken becomes dark.
•
Was this picture taken with the flash at the close range when the zoom is near [W] (1k)?
> Zoom in a little, and then take the pictures. (P31)
•
Is this a picture taken in [PIN HOLE] in scene mode?
The recorded picture is too bright or dark.
> Check that the exposure is correctly compensated. (P45)
•
Setting the [MIN. SHTR SPEED] to faster speed might make the picture darker.
> Set the [MIN. SHTR SPEED] to slower speed.
2 or 3 pictures are taken at one time.
> Set auto bracket (P46)/colour bracket (P46), [HI-SPEED BURST] (P53), [FLASH BURST]
(P54) in scene mode or [BURST] (P70) of the [REC] mode menu to [OFF].
The subject is not focused properly.
•
The focus range varies depending on the recording mode.
> Set to the proper mode for the distance to the subject.
•
The subject is beyond the focus range of the camera. (P29)
•
There is camera shake (jitter) or the subject is moving slightly. (P30)
The recorded picture is blurred.
The optical image stabilizer is not effective.
> The shutter speed becomes slower when pictures are taken in dark places so hold the
camera firmly with both hands to take the pictures. (P26)
> When taking pictures at a slow shutter speed, use the self-timer. (P44)
Taking pictures using auto bracket/colour bracket is not possible.
•
Is the number of recordable pictures 2 or less?
The recorded picture looks rough.
Noise appears on the picture.
•
Is the ISO sensitivity high or the shutter speed slow?
(ISO sensitivity is set to [AUTO] when the camera is shipped. Therefore, when taking pictures
indoors etc. noise will appear.)
> Decrease the ISO sensitivity. (P64)
> Increase the setting for [NOISE REDUCTION] in [PICT.ADJ.] or lower the setting for each
of the items other than [NOISE REDUCTION]. (P73)
> Take pictures in bright places.
•
Has [HIGH SENS.] or [HI-SPEED BURST] in the scene mode been set? If so, the resolution of
the recorded picture decreases slightly because of high sensitivity processing, but this is not a
malfunction.
The brightness or the hue of the recorded picture is different from the actual
scene.
•
If recording under fluorescent light, the brightness or the hue may change slightly when the
shutter speed becomes fast. This occurs due to the characteristics of fluorescent light. It is not
a malfunction.
Others
115
VQT1T00