Others
∫ Functions that cannot be used when the component cable is connected
[LCD MODE]/[HISTOGRAM]/[TITLE EDIT]/[TEXT STAMP]/[RESIZE]/[TRIMMING]/
[LEVELING]/[ASPECT CONV.]/[AUDIO DUB.]/[COPY]/[MULTI] settings of [DPOF PRINT]/
[MULTI] settings of [PROTECT]/[DELETE MULTI]/Creation of still pictures from motion
pictures
Troubleshooting
First, try out the following procedures (P114–120).
If the problem is not resolved, it may be improved by selecting [RESET] (P23) on the
[SETUP] menu when taking pictures.
The camera cannot be operated even when it is turned on.
•
The battery is not inserted correctly. (P14)
•
The battery is exhausted.
The LCD monitor turns off while the camera is turned on.
•
Is [AUTO LCD OFF] (P22) of the [ECONOMY] mode active?
> Press the shutter button halfway to cancel these modes.
•
The battery is exhausted.
The camera turns off immediately after it is turned on.
•
The battery is exhausted.
•
If you leave the camera on, the battery will be exhausted.
> Turn the camera off frequently by using the [ECONOMY] mode etc. (P22)
The [CHARGE] lamp flashes.
•
Is the temperature of the battery excessively high or low? If it is, it will take longer than usual to
charge the battery or charging may remain incomplete.
•
Are the terminals of the charger or battery dirty?
> Wipe off the dirt using a dry cloth.
The picture cannot be recorded.
•
Is the [REC]/[PLAYBACK] selector switch at the [!] setting? (P25)
•
Is the mode dial correctly set?
•
Is there any memory remaining on the built-in memory or the card?
> Delete the pictures which are not necessary to increase the available memory. (P35)
The recorded picture is whitish.
•
The picture can become whitish if there is dirt e.g. fingerprints on the lens.
> If the lens is dirty, turn on the camera, eject the lens barrel (P11) and gently wipe the lens
surface with a soft dry cloth.
114
VQT1T00
Battery and power source
Recording