Installation And Connection - Panasonic Inverter NN-L564 Operating Instructions Manual

Microwave/grill/convection oven
Hide thumbs Also See for Inverter NN-L564:
Table of Contents

Advertisement

Installation and Connection

Examine your microwave oven
Unpack the oven, remove all packing material,
and examine the oven for any damage such
as dents, broken door latches or cracks in the
door. If you find any damage, notify your
dealer immediately. Do not install a damaged
microwave oven.
Earthing instructions
IMPORTANT: THIS UNIT HAS TO BE
PROPERLY EARTHED FOR PERSONAL
SAFETY.
If your AC outlet is not grounded, it is the
personal responsibility of the customer to have
it replaced with a properly grounded wall
socket.
Operation voltage
The voltage has to be the same as specified
on the label on the oven. If a higher voltage
than specified is used, it may cause a fire or
other damages.
Placement of the Oven
1. Place the oven on a flat and stable
surface, more than 85 cm above the floor.
2. When this oven is installed, it should be
easy to isolate the appliance from the
electricity supply by pulling out the plug or
operating a circuit breaker.
3. For proper operation, ensure a sufficient air
circulation for the oven.
Counter-top use:
a. Allow 15 cm of space on the top of the
oven, 10 cm at the back, 5 cm on one
side, and the other side must be
opened more than 40 cm.
b. If one side of the oven is placed flush to
a wall, the other side or top must not be
blocked.
15cm
5cm
Counter-top
4. Do not place this oven near an electric or
gas cooker range.
5. The feet should not be removed.
6. This oven is only for household usage. Do
not use outdoors.
7. Avoid using the microwave oven in high
humidity.
8. The power cord should not touch the
outside of the oven. Keep the cord away
from hot surfaces. Do not let the cord hang
over the edge of a table or work top. Do
not immerse the cord, plug or oven in
water.
9. Do not block the air vents on the top and
back of the oven. If these openings are
blocked during operation the oven may
overheat. In this case the oven is
protected by a thermal safety device and
resumes operation only after cooling down.
WARNING
1. The door seals and door seal areas should
be cleaned with a damp cloth.
The appliance should be inspected for
damage to the door seals and door seal
areas and if these areas are damaged the
appliance should not be operated until it
has been repaired by a service technician
trained by the manufacturer.
2. Do not attempt to tamper with or make any
adjustments or repairs to the door, control
panel housing, safety interlock switches or
any other part of the oven. Do not remove
the outer panel from the oven which gives
protection against exposure to microwave
energy. Repairs should only be done by
a qualified service person.
3. Do not operate this appliance if it has a
damaged CORD OR PLUG, if it is not
working properly, or if it has been damaged
or dropped. It is dangerous for anyone
other than a service technician trained by
the manufacturer to perform repair service.
4. If the supply cord of this appliance is
damaged, it must be replaced with the
special cord available from the
10cm
manufacturer.
5. Only allow children to use the oven without
supervision when adequate instructions
Open
have been given so that the child is able to
use the oven in a safe way and
understands the hazards of improper use.
6. Liquids and other foods must not be heated
in sealed containers since they are liable to
explode.
En-1

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Inverter nn-l554

Table of Contents