Changing The Channel Selection - Sony WRT-805A Operating Instructions Manual

Changing the Channel Selection

1
Set the unit to Setting mode.
If the channel number is not displayed, press the SET
button to obtain the channel number indication.
2
Press the + or – button to select the channel.
Pressing the + button cyclically changes the channel
indication in the order shown in the table of "Channels
and Carrier Frequencies" on page 6. Pressing the –
button changes it in reverse order.
AF RF BATT
+ button
– button
CH
If you keep either button pressed, the channel setting will
be incremented or decremented successively.
The display will cycle from 68-01 through 69-47.
68-01 68-02
69-47
AF RF BATT
CH
68-47
69-02 69-01
3
Once the desired channel number appears, set the
POWER switch to OFF to release Setting mode.
Or, press the SET button to continue operations in Setting
mode.
The next time you turn on the power only by setting the
POWER switch to ON, the transmitter will be set to
Transmit mode with the selected channel.
Notes
•
The unit cannot transmit in Setting mode.
•
Make sure that the channel selected is the same as that
selected on the tuner used in the same system.
•
Depending on the noise or interference conditions, the
selectable channels may not necessarily all be usable. If
necessary, you can determine the usable channels by
stepping the channel selection through a number of
channels on a tuner with the transmitter set to OFF. Those
channels on which the RF indicator of the tuner does not
light are usable.
•
If there is a TV broadcasting station near by, do not use
the station's channel.
•
The unit may not operate correctly if it is turned on again
immediately after turning off the power while in setting
mode. Pause for a few seconds or more before turning on
the power again.
13