Siemens Gigaset AS300 User Manual page 5

Placing the handset in the base station and registering
V
Put into base
MENU
V
Registering
V
INT MENU
If you have purchased a model with multiple handsets, repeat the registration process for
each individual handset. Handsets are assigned the lowest available internal number (1–4). If
more than one handset is registered to the base station, the internal handset number appears
in the top left of the display, e.g. 2. If the internal numbers 1–4 are already assigned to other
devices, number 4 will be overwritten.
Please note
◆
Each key press interrupts the automatic registration.
◆
¢
If automatic registration does not work, the handset will have to be registered manu-
ally ( page 10).
◆
Only place the handset in the base station or charging cradle that is intended for it.
Initial charging and discharging of the batteries
The correct charge level can only be displayed if the batteries are first fully charged and dis-
charged.
¤
Place the handset in the base station or charging cradle for eight hours.
¤
Then remove the handset from the base station or charging cradle and do
not replace it until the batteries are fully discharged.
8 h
5
Before you can use the phone, you must first register the handset
to the base station.
¤
Place the handset with
the display facing up
in the base station.
The handset registers automatically.
Registration can take up to 5 minutes.
Do not remove the handset from
the base station during this time.
After successful registration, the idle screen is displayed.
Charge status of the batteries:
= e V U
– (flat to full)
=
– flashes: batteries almost flat
e V U
– flashes: charging