Automatic Redialling - Sharp UX-BS60 Operation Manual

Sending a Fax by Automatic Dialling
Redial
You can automatically redial the last number dialled on the fax machine. This
procedure can be used to send a fax or make a phone call.
1
If you are sending a fax, load the
document(s).
•
If desired, press
resolution and/or contrast.
2
Press
number dialled. Make sure the number that appears is the number you
wish to dial.
3
If you are sending a fax, press
If you are making a phone call, lift the handset. Dialling begins.
Note: If the transmission is unsuccessful and DOCUMENT JAMMED appears
in the display, remove the document as explained on page 128. (This may
occur if the other fax machine doesn't respond properly when you attempt to
send the document.)

Automatic redialling

If you use automatic dialling (including Direct Keypad Dialling) to send a fax
and the line is busy, the fax machine will automatically redial the number. The
fax machine will make three redial attempts at intervals of five minutes. During
this time, RECALLING will appear in the display, followed by a two-digit
number assigned to the fax job. You will not be able to dial any other locations
while the message appears.
80
RESOLUTION/
RECEPTION
to set the
once. <REDIAL> appears in the display, followed by the last
START/
MEMORY
. Dialling begins.
29-MAY 12:00
READY TO SEND