Sharp UX-385 Operation Manual page 48

Using TEL Mode
Answering with an extension
phone
1
Answer the extension phone when
it rings.
2
If you hear a fax tone when you
answer an extension phone, wait
until your fax answers (the
extension phone will go dead), and
then hang up.
Beep
3
If the fax doesn't respond, or if the
other party first talks to you and
then wants to send a fax, press 5,
*, and * on the extension phone
(only on a tone dial phone). This
signals the fax to begin reception.
Hang up.
5
46
Phone goes dead
Comments:
Your fax will not accept the signal
to begin reception (5**) if a
document is loaded in its feeder.
If you have set Option Setting 16 to
NO and hear a fax tone when you
answer the extension phone, you
must press 5, *, and * if you are
on a tone dial phone, or walk over
to the fax, pick up the handset, and
press the START/MEMORY key if
you are on a pulse dial only phone.
The code used to activate fax
reception from a tone dial
extension phone (5**) can be
changed if desired. See Option
Setting 5 (Tel/Fax Remote
Number) in Chapter 8, Option
Settings.