Advertisement
Manual URC 4689 UK Apr05.fm Seite 6 Montag, 11. April 2005 12:00 12
ALL OFF function
You can switch off all pre-programmed devices simultaneously. Proceed as
follows:
1. Briefly press the ALL OFF key. The selected device will be switched off
and the corresponding MODE key will light up.
2. Press the ALL OFF key immediately once again and keep it pressed for
approx. 3 seconds. Now, all pre-programmed devices are switched off one
after another. This will take about 3 seconds. Then, the MODE key
illumination will go out. The remote control has to be pointed at the
devices to be operated until the MODE key goes out.
Some devices can be switched on and off by means of the POWER key. These
devices will be switched ON with the ALL OFF function if they were turned
OFF.
Toggle function
You can zap between 2 channels by pressing the P<P key. Proceed as follows:
1. Switch on manually the device you wish to control (TV, VCR, ...)
2. Keep the SET key pressed for approx. 3 seconds until the LED indicator
lights continuously.
3. Release the SET key.
4. Press P<P and the mode key of the device you wish to control.
5. Enter the first channel number (3 digits as maximum).
6. Press again P<P and the mode key of the device you wish to control.
7. Enter the second channnel number (3 digits as maximum).
8. Press P<P to end the setting.
Certain TV sets have also a toggle function (depending on the manufacturer, it
can zap from the present and the previous channel). This function can be
activated by pressing the A/V or -/-- keys on your remote control.
Autozapping
In case of TV operation, you will successively go through all stored channels by
once pressing the SHOWVIEW key (the remote control has to be pointed
permanently at the device). Press the CHAN– key once to finish the function.
Normal operation
After having programmed your remote control for your audio/video devices,
your remote control will in respect of the most common main functions work
like the original remote control of the respective device.
Point your remote control at the respective device and press the appropriate
MODE key. All functions will now be activated by pressing the respective
function key of your remote control.
For each transmitted IR signal, the LED lights up.
6
Hide quick links:
Advertisement
